Progress PDG9140E Manuale Utente Scaricare il pdf (Pagina 42)

progress

INSTALLATION

Wall drilling and bracket ﬁ xing

As a ﬁ rst step, proceed with the following drawings:

• Draw a vertical line on the supporting wall up to the ceiling, or as high as practical, at the centre of

the area in which the hood will be installed.

• Draw a horizontal line at 650 mm above the hob.

• Place bracket 7.2.1 on the wall as shown about 1-2 mm from the ceiling or upper limit aligning the

centre (notch) with the vertical reference line.• Mark the wall at the centres of the holes in the bra-

cket.

• Place bracket 7.2.1 on the wall as shown at X mm below the ﬁ rst bracket (X = height of the upper

chimney section supplied), aligning the centre (notch) with the vertical line.

• Mark the wall at the centres of the holes in the bracket.

• Mark a reference point as indicated at 116 mm from the vertical reference line and 306 mm above

the horizontal reference line.

• Repeat this operation on the other side.

• Drill ø 8 mm holes at all the centre points marked.

• Insert the wall plugs 11 in the holes.

• Fix the lower bracket 7.2.1 using the 12a screws (4,2 x 44,4) supplied.

• Fix the upper bracket 7.2.1 and the air outlet connection support 7.3 together using the 2 screws

12a (4,2 x 44,4) supplied.

• Insert the two screws 12a (4,2 x 44,4) supplied in the hood body ﬁ xing holes, leaving a gap of 5-6

mm between the wall and the head of the screw.

12a

306

116

1÷2

116

650 min.

7.2.1

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 75 76

Nessun commento

Progress PDG9140E Manuale Utente Pagina 42